Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Bathroom Remodeling: The San Diego Owner’s Guide
ActiveYards bathroom remodeling in San Diego typically runs $10,620-$33,040 installed, with most projects we quote landing in the mid-teens to low-twenties depending on fixture count and whether we’re moving walls. We stock ActiveYards-compatible enclosures, hardware kits, and waterproofing components, and we can usually get a crew out for measurement within a few days of your call. Most San Diego homeowners realize something’s wrong when the enclosure frame starts weeping at the corners or the sliding panel drags because the track has bowed from moisture swelling the substrate underneath.
Which ActiveYards Models This Applies To
ActiveYards organizes their bathroom and shower enclosure lines by frame depth and glass thickness, not by catchy model names, so the label that matters is the spec sticker on the hinge jamb or track rail. Look for a four-digit series code starting with 4 (3/16-inch glass, residential grade) or 6 (1/4-inch glass, heavier frame). The 6-series uses a wider wall jamb, about 2-1/8 inches, and the roller hardware is not interchangeable with the 4-series even though the glass height might be the same. We’ve seen San Diego homeowners order 4-series replacement rollers for a 6-series unit and wonder why the door still binds.
OEM ActiveYards hardware comes in branded packaging with a yellow and black parts card. Aftermarket equivalents from Prime-Line or Slide-Co will fit the track geometry, but the roller axle diameter varies, 5/16 inch versus 3/8 inch, and mixing them cracks the nylon wheel in about eighteen months. We stock both on our truck in San Diego because some customers want the warranty coverage of OEM and others need the job done this week at a lower parts cost. Measure twice, document once, then we can talk price.
Signs Your ActiveYards Bathroom Remodeling Is Failing

- Water staining on the drywall outside the enclosure. The silicone seal between the wall jamb and tile has failed, or the weep holes in the track are clogged with hard-water scale. In San Diego’s mineral-heavy water, we see this on north-facing bathrooms where the enclosure dries slowly.
- Sliding door drops or binds in the track. The roller axle has worn flat spots, or the track itself has deformed from moisture getting into the substrate below. ActiveYards tracks are aluminum, but they’re only as straight as the 2×4 they’re screwed to.
- Frame corners weeping during a shower. The corner keys, the plastic brackets that square the frame, have cracked from thermal cycling or from being overtightened at install. OEM corner keys are glass-filled nylon; the cheap replacements are ABS and fail faster.
- Glass panel rattles in the wind or when the door closes. The vinyl glazing bead has hardened and shrunk, which happens faster in San Diego’s dry inland valleys than near the coast. The glass is no longer cushioned and can chip at the edges.
- Threshold leaks onto the bathroom floor. The sweep or drip rail at the bottom of the door has torn, or the track-to-threshold seal was never bedded in silicone properly. On slab-on-grade homes in Clairemont or Mira Mesa, this water has nowhere to go but across the floor.
Before
AfterReplacement Cost & What’s Included
A full ActiveYards bathroom remodel in San Diego runs $10,620-$33,040, with the typical 5×8-foot hall bath with standard enclosure landing around $14,000-$18,000. That includes demolition to studs, new waterproofing membrane (we use Schluter-Kerdi or an equivalent liquid-applied system), tile or solid-surface walls, the ActiveYards enclosure or a compatible upgrade, vanity replacement, toilet reset, and all trim. A partial replacement, just the enclosure and surround with no plumbing relocation, usually falls between $5,900-$14,160.
What moves the number: moving the drain or valve location, switching from tub to curbless shower (requires slope modification and often a linear drain), and whether the substrate behind the tile is still sound. We put the full scope in writing before work starts, every line item priced, and no change proceeds without a signed change order. Under Clause 1 of the Haven Standard, the price you agree to is the price you pay, within a few percent. Our 365-Day Done Right Promise covers the workmanship, and the photo record we deliver at completion shows what we found and what we did.
DIY or Call Us?

There’s a safe middle ground here. A homeowner can check the weep holes with a pipe cleaner, verify the sweep isn’t torn, and confirm the door rollers aren’t obviously cracked. That’s about where we recommend stopping. Removing an ActiveYards frame means dealing with tempered glass panels that weigh sixty-plus pounds each, and the frame is screwed through tile into studs that may be wet or rotten behind the wall. We’ve opened enclosures in San Diego homes where the framing was black with mold six inches past the visible stain.
The waterproofing layer, whether it’s a sheet membrane or a liquid system, is the critical barrier between your bathroom and the subfloor. Getting it lapped correctly at the curb and sealed at the drain flange takes practice; we’ve redone enough DIY jobs where the owner used Redgard too thin or missed the corner reinforcement strips. If you’re weighing the time and the risk, call (858) 434-8926 and we’ll measure it out, show you the substrate condition with photos, and give you a written price before anyone picks up a demolition hammer.
FAQs
With proper installation and ventilation, fifteen to twenty years on the frame and hardware, though the seals and sweeps need replacement every five to seven years in hard-water areas. Coastal salt air can accelerate corrosion on non-anodized hardware, which is why we specify anodized or stainless components for ocean-adjacent homes in La Jolla or Pacific Beach. Call (858) 434-8926 for an exact quote on your enclosure, estimates are free.
Individual components, corner keys, rollers, sweeps, and glazing bead can be replaced if the frame geometry is still square and the substrate behind it is dry. Once the wall jambs have been leaking long enough to swell the framing or delaminate the tile backer, partial repair is false economy; we’ve been called back six months later to do the full job anyway. Call (858) 434-8926 and we’ll tell you honestly which situation you’re in.
Two to three weeks for a standard 5×8-foot bathroom with no plumbing relocation, assuming materials are in stock and inspections are on schedule. San Diego permitting adds three to five business days for plumbing and electrical rough inspections, which we coordinate; the project timeline in your written quote includes realistic inspection windows, not best-case fantasy. Call (858) 434-8926 to schedule a measurement and we’ll give you a date-specific timeline.
We stock common rollers, sweeps, corner keys, and track thresholds on our service trucks, and we maintain a local inventory of Schluter waterproofing materials and standard tile formats. Full enclosures or custom glass sizes ship from ActiveYards’ regional warehouse in two to three business days. Call (858) 434-8926 to confirm availability for your specific series code.
Written by Grant Rowan, Owner, Rowan Construction Group San Diego at Rowan Construction Group San Diego, serving San Diego and nearby areas.







Before
After
Before
After
Before
After